Get Oppo Find X3 Pro CPH2173 Flash File

Oppo Find X3 Pro CPH2173 : To install the firmware flash file, we need a software called QFil Flash Tool which can be helpful to flash the stock ROM on your device.

The method is simple and easy. Oppo Find X3 Pro CPH2173 Flash File can be used to fix hang on the logo and remove all screen locks. This file will remove all type of screen lock like Pattern and frp after flash.

Download Oppo Find X3 Pro CPH2173 Flash File

Follow the steps below to flash the firmware. Hold volume up, volume down, and power button to enter the menu and chose flash.

On the Flash Firmware screen, press and hold any button to select the bookmarks, then hit the large flashing button to start flashing.

QFil Flash Tool also supports OTA Updating of your firmware. Normally the procedure to flash the OTA update would be also very simple, but for the Oppo Find X3 Pro the process is more complicated.

Due to the nature of QFil Flash Tool, you must plug your device to PC to download the update.

  • Open QFilflash fully, and all the drivers will be installed automatically. Choose the devices you wish to flash and install the file on them.
  •  Some of the issues are caused by the software / hardware incompatibility of the device, OS is not compatible, but firmware is compatible preventing the device to receive the control messages.
  • The firmware has nothing to do with rogue apps installed by the user. We have confirmed the error by permanently uninstalling all the rogue apps from the device.
  • The scenario is the following: The stock firmware enabled when you first connect the phone to the PC is the one that causes the problem. It turned the screen to static and when it’s turned off, all the displayed sound is distorted. This is the case, also in the case of the flow bar that gives an error message on the screen

*If you don’t see the group of buttons that is used as Back, Home, Pause, and Power, please unplug and replug your phone for about 10 minutes to see if the issue becomes visible.

The software will only fix the first screen of the phone when we boot up it after flashing the firmware. Here are the trick before erase to enter the settings mode on boot.

  •  Press volume up to enter the bootloader screen (after volume down, if screen is off)
  • Select the option ‘Press to enter bootloader’
  • After choosing the option, press ‘TAB’ and the device will enter into the bootloader mode.
  • Wait till the device successfully enters into the bootloader mode and then press the volume down button once more to enter the grub menu.
  • Select the option to Legacy boot and then press ok.
  • You will then be brought to the grub menu which basically controls how the OS loads the software on the device.
  1.  Erase flash: Select it to Erase flash
  2. Disable 64-bit boot: Select it to Disable 64-bit boot
  3. Do a hard reset: Select it to Do a hard reset
  • Select the option Do a factory reset when press any key on the following screen.
  • Select the option to install the QFirmware

“Installing QFlash Tool now.”

  • Select the option to Allow. If the error reported below is not found, confirm by selecting the option ‘Yes’.

After flashing and entering the settings, you can proceed with booting your device.

  • The second screen will show if the only connection is made with the left tab, and allow the device. If connected correctly, the logo of device will be changed instantly and only the status will be shown at the right.

Oppo Find X3 Pro CPH2173 Firmware/Flash File Details:

  • Device : OPPO Find X3 Pro (CPH2173)
  • ROM Type: Stock ROM/ Flash Files/Ota Firmware
  • Processor: Qualcomm® Snapdragon™ 888
  • Android Version: Realme UI v1.0 (Based on Android 10)
  • Size : 4.4GB, 13GB, 11.6GB

CLICK HERE: LINK-01  LINK-02  LINK-03

Please Share:

Leave a Comment